All Articles

A successful MetalCloak steering system install is about more than just beefy parts; it’s about restoring the steering geometry and eliminating the "cumulative slop" we’ve been researching. As we found with the upper control arms, every pivot point matters.

How deep into the rabbit hole are you willing to go to find a ticking sound? Is it better to ignore the noise and risk getting stranded, or do you tear it all down and pray you don't make things worse? This is my story of trying, failing, and opening a $162 can of worms that cost me more than just money.

If you’re pulling the passenger-side axle on a Jeep Gladiator (JT) or Wrangler (JL), you’ve probably realized there is a major "gotcha" waiting for you inside the axle tube. It’s called the FAD, or Front Axle Disconnect. Many DIYers treat the passenger side like the driver side—just pull it out and shove it back in. But if you do that, you’re going to hit a wall. Or worse, you’ll ruin an expensive inner axle seal. This guide, born out of my extensive "Death Wobble Nuclear Op

If you are battling the dreaded front-end shimmy, a Dynatrac Ball Joint Install is often considered the "Nuclear Option" for a reason. Unlike standard factory units, these ProSteer heavy-duty joints are built to handle the added leverage of larger tires and off-road abuse. The beauty of this system is that they are rebuildable on the vehicle. Once you press them in this time, you’ll never have to use a ball joint press on those knuckles again.

When you’re dealing with a Jeep Gladiator or Wrangler shaking itself apart, sometimes you have to stop chasing small fixes and go nuclear. That is exactly what I’m doing in Part 5 of my Death Wobble series. Today, we are performing a MetalCloak Track Bar install to replace the thin, hollow factory unit with something that actually has the "beef" required for heavy off-road use.

I didn't realize how much a steering box could flex until I started chasing the death wobble on this 2022 Jeep Gladiator Rubicon. Today, we're beefing up the steering to stop the shake. Welcome to Muddy Ruttzz. This is part 4 of our series, and while no single part is a "silver bullet," this Jeep Sector Shaft Brace is a critical piece of the puzzle. By the time we finish this build with Metalcloak and Dynatrac components, this Gladiator should drive better than the day it le

When you’re fighting the dreaded "Death Wobble," most people focus entirely on the front end. However, you can’t have a rock-solid front end without a stable rear. Installing a heavy-duty Jeep Gladiator Rear Track Bar is one of the easiest ways to start your teardown and build-up process.

If your steering wheel is shaking so hard it feels like a 7.0 on the Richter scale, you’re in the right place. While I am performing this build on my 2022 Jeep Gladiator Rubicon, the components and geometry principles involved in the "Nuclear Option" apply directly to:Jeep Gladiator (JT) * Jeep Wrangler (JL & JK) The Goal: Stop "guessing" with steering stabilizers and address the root cause by replacing weak, plastic-seated factory parts with heavy-duty, solid steel alternat